Bobcat 463 Error Codes

Bobcat 463 Error Codes were written to give the owner / operator instructions on the safe operation and maintenance of the Bobcat vehicle.

Viewing Service Codes At Bobcat 463

Press the Information button to cycle the data display until the service code screen is displayed. If more than one service code is present, the codes will scroll on the data display.

Engine and Operations

The Bobcat 463 had a 1.0-liter 22.5 horsepower Kubota D1005-E engine with three cylinders. The 463 engine took diesel fuel and had a displacement of 61.1 cubic inches. The Bobcat 463 had a hydrostatic, four-wheel drive transmission. The hydraulics on the Bobcat 463 were able to lower and lift the arms and bucket. Two hand levers controlled the Bobcat 463's speed and steering.

Performance

The Bobcat 463 had a rated operating capacity of 700 pounds, a tipping capacity of 1,405 pounds and an operating weight of 2,708 pounds. The Bobcat 463 could reach 6.5 mph and used 5.7 inch by 12-inch standard tires. The Bobcat also had a hydraulic pump capacity of 10 gallons per minute to move the variety of attachments, including a utility grapple, snow blower and buckets.

Dimensions

The Bobcat 463's length with the bucket attachment was 100.8 inches and the length without the bucket attachment was 75.5 inches. The width of the Bobcat 463 was 35.4 inches without a bucket attachment and 36 inches was the width with a bucket attachment. The height of the Bobcat was 71.4 inches and height to bucket hinge pin was 94.5 inches. The Bobcat turning radius was 61.3 inches and it had a wheelbase of 28.4 inches.

Features, Options and Accessories

The Bobcat had a variety of features, including front lights, rear lights, an operator cab, front auxiliary hydraulics and lift arm support. It also had options from a reverse alarm, a cab heater, key-less start kit, rotating beacon, a suspension seat and a top window. The attachments for the 463 varied from an angle broom, backhoe, breaker, bucket, pallet fork, snow blower, trencher and a utility fork.

BOBCAT 463 SERIAL NUMBER LOCATIONS

Always use the serial number of the loader when requesting service information or when ordering parts. Early or later models (identification made by serial number) may use different parts, or it may be necessary to use a different procedure in doing a specific service operation.

Serial Number

Bobcat 463 serial number plate is located on the outside of the loader frame.

Explanation of Serial Number:

The four digit Model / Engine Combination Module number identifies the model number and engine combination.
The five digit Production Sequence Number identifies the order which the loader is produced.

Bobcat 463 Error Code List

View list of Bobcat 463 model fault codes.

Totally 3843 bobcat fault codes.

BOSS SERVICE CODES

AF - Air Filter

b - Battery

FUEL - Fuel Level

HC - Hydraulic Oil Temperature

HF1 - Hydraulic Charge Filter

HF2 - Engine Return Filter

EC - Engine Coolant Temperature

ECL - Engine Coolant Level

EP - Engine Oil Pressure

ES - Engine Speed

HP - Hydraulic Oil Pressure

uP - BOSS Warning

-1 - Shutdown (Engine can be restarted for 30 second periods to move loader)

-2 - Warning

-3 - Wiring Not Connected

-4 - Wiring Shorted

-5 - High Sensor Voltage

-6 - No Signal

-7 - Out of Range